Search

Metrology for structural and electrical analyses at device level has been identified as one of the major challenges to be resolved for the sub-14 nm technology nodes. In these advanced nodes, new high mobility semiconductors, such as III–V compounds, are grown in narrow trenches on a Si substrate. Probing the nature of the defects, the defect density, and the role of processing steps on the surface of such structures are prime metrology requirements. In order to enable defect analysis on a (III–V) surface, a proper sample preparation for oxide removal is of primary importance. In this work, the effectiveness of different chemical cleanings and thermal annealing procedures is investigated on both blanket InP and oxide embedded InP trenches by means of scanning probe microscopy techniques. It is found that the most effective approach is a combination of an HCl-based chemical cleaning combined with a low-temperature thermal annealing leading to an oxide free surface with atomically flat areas. Scanning tunneling microscopy (STM) has been the preferred method for such investigations on blanket films due to its intrinsic sub-nm spatial resolution. However, its application on oxide embedded structures is non-trivial. To perform STM on the trenches of interest (generally <20 nm wide), we propose a combination of non-contact atomic force microscopy and STM using the same conductive atomic force microscopy tip Our results prove that with these procedures, it is possible to perform STM in narrow InP trenches showing stacking faults and surface reconstruction. Significant differences in terms of roughness and terrace formation are also observed between the blanket and the oxide embedded InP. [ABSTRACT FROM AUTHOR]

We use an improved AC conductance method and a modified Gray-Brown method to study fast interface traps and slow border traps in Ge-based MOS capacitors. The combined methods provide the corrected Fermi energy level (E) versus gate voltage (Vg) relationship, even in samples with high densities of traps that cause significant C-V distortion, the energy distribution of interface traps, their capture cross sections (σ), as well as slow border traps. A wide range of σ's in p-type Ge is found, indicating that there is more than one type of interface trap near the Ge valence band edge. In contrast, a constant σ near the Ge conduction band edge is observed in n-type Ge. XPS results indicate that Ge suboxides near the interface are accountable for the detected slow border traps. [ABSTRACT FROM AUTHOR]

The efficiency of the ammonium sulfide vapor (ASV) treatment, as opposed to the wet treatment in the liquid ammonium sulfide solution, on the performance improvement of the In0.53Ga0.47As surface-channel as well as InP-capped buried-channel metal-oxide-semiconductor field-effect-transistors (MOSFET) was demonstrated for the first time. MOSFETs were fabricated with either HCl or ASV surface treatments prior to the gate oxide deposition. ASV treatment was found to be very efficient in boosting the drive current of the transistors compared to that of the HCl treatment. It was also found that the ASV treatment leads to a lower border trap density and slightly higher oxide/semiconductor interface defect density compared to that of the HCl treatment. X-ray photoelectron spectroscopy (XPS) studies of In0.53Ga0.47As native oxide regrowth after both surface treatments identified indium sub-oxides as a possible cause of the performance degradation of the HCl treated devices. Based on this work, ASV treatment could be an efficient solution to the passivation of III-V surfaces. [ABSTRACT FROM AUTHOR]