Search

This research aimed to develop a reliable, easy-to-perform and cheap method for measuring protein oxidation in complex samples such as aquaculture feed within various protein sources. For that purpose modified 2,4-dinitrophenylhydrazine (DNPH)-based method for quantification of protein carbonyls was employed whilst the modification of the method consisted of using different solutions for the extraction (distilled water and different concentrations of KCl and NaCl solutions), time of protein extraction (after homogenization and over the night) and concentration of trichloroacetic acid (10 and 25% TCA) for protein precipitation. Extraction during the night, higher TCA concentration and the use of 0.5 M KCl extraction solution resulted in the highest protein amount measured by the Lowry method and 280 nm protein estimation. On the other hand, the lowest protein yield was obtained by using distilled water for the extraction. Furthermore, the lowest amount of protein carbonyls was in the case when extraction was performed with distilled water (DW), while the highest content of protein carbonyls was reached with 0.15 M KCl and 0.5 M KCl extraction solutions. It was observed that the amount of proteinbound carbonyls compounds was increasing during storage under accelerated conditions and, in comparison to the original method, the modified method for measuring protein oxidation resulted in a higher amount of carbonyls during all points of storage.

Oxidative changes in fish feed during storage are a major problem in aquaculture nutrition. The current study aims to present fast and simple spectrometric method to measure thiobarbituric acid reactive substances (TBARS) in the commercial rainbow trout feeds without hydrolysis step, as a method for determination of lipid peroxidation. The proposed test was validated and relevant method characteristics which were evaluated within the validation protocol were: linearity (range), limit of detection, limit of quantification, precision (repeatability and intra-laboratory reproducibility), accuracy and method performance (Xand R-control charts). The obtained results indicated that presented TBARS test was linear in the range of 1.11-13.33 nmol/mL and precise under both repeatability and reproducibility test conditions. The method was characterized by acceptable accuracy considering low analyte concentration in the samples. The method also showed to be stable in terms of changes in the average level and variability. The results in the present work indicated that the proposed test could be successfully applied for TBARS quantification in rainbow trout feed for routine quality control in aquaculture sector, especially in case when need to analyse a great number of samples in a short time.

In the past few decades the diet preparation in feed production has evolved towards more complicated technological operations, which include different liquid addition. A wide scale of different liquids is used in contemporary animal feed production, from oils and glycerol to more expensive products in a liquid form, such as enzymes, flavourings, amino acids, vitamins and others. In the presented study the liquid addition in feed production was observed, with a specific goal to investigate the spraying systems in order to better understand the effects of fluids, such as soybean oil and glycerol, on feed production. The dispersion angles of spraying nozzle for glycerol and soybean oil were determined as an indicator of the uniform application of liquids during feed production. Dispersion of the material was accomplished using the two-fluid nozzle. The performance of Artificial Neural Network (ANN) was compared with experimental data in order to develop rapid and accurate method for prediction of dispersion angle. The ANN model showed high prediction accuracy (r2 = 0.945). [Project of the Serbian Ministry of Education, Science and Technological Development, Grant no. III46012]

For many years, linseed has been attracted a great attention in animal nutrition because of its exceptionally favourable fatty acid composition and high content of essential α-linolenic acid. However, the presence of antinutritive components, cyanogenic glycosides, limits its inclusion in the animal's diet. Several ways of linseed detoxification were observed in literature, emphasizing extrusion as one of the most effective processes. In the presented study, the application of Artificial Neural Network (ANN) has been observed, as a tool for prediction of process influence on the deterioration of cyanogenic glycosides during the extrusion process of linseed-sunflower meal co-extrudate. The content of hydrogen cyanide (HCN) was determined according to the AOAC method as an indicator of cyanogenic glycosides in the produced co-extrudate. Extrusion of the material was performed on a laboratory single screw extruder. The performance of ANN model was compared with experimental data in order to develop rapid and accurate method for prediction of HCN content in co-extrudate. According to the experimental results, the highest HCN content (126 mg/kg) was determined at the lowest moisture content (7%) and the lowest screw speed (240 rpm). With the increase of moisture content and temperature during extrusion, the content of HCN drastically decreased. The ANN model showed high prediction accuracy (r2> 0.999), which indicates that the model could be easily and reliably applied in practice.

For many consumers egg yolk color is a very important characteristic of egg quality. Since hens are not able to synthesize coloring pigments, the intensity of the yolk color depends directly on the content and profile of pigmenting carotenoids present in their feed. The aim of this study was to assess the combined pigmenting effect of paprika and carrot and their ability to achieve egg yolks in the desired color range. Biological tests lasted for 30 days and were conducted on 180 Lohmann Brown layers. The laying hens were divided in six groups. Every group was assigned to one of six possible treatments, control 1 (C1) treatment without any pigments added, control 2 (C2) treatment with synthetic pigments added and four experimental diets (D1, D2, D3, D4) with the addition of natural color sources (paprika and carrot). After experimental period collected eggs were analyzed regarding physical characteristics of eggs, content of β-carotene and yolk color of eggs. Obtained results has shown that dried carrot and milled paprika can successfully replace synthetic pigments, with no negative effects on physical characteristics of produced eggs, egg yolk color, acceptability or β-carotene content.

Water stability of eight samples of extruded salmon feeds was first determined by applying two gravimetric methods developed by the authors: gravimetric static and wet sieving method. Then, the conductometric method, primarily developed for investigation of nutrient leaching of feed into the water by the authors, was used for each sample. The aim of this study was to evaluate the potential of the conductometric measurement as a technique for determining water stability of extruded fish feed. In order to find any correlation between the results of two gravimetric tests and conductometric method, correlation analysis was employed. The results of static and wet sieving method were expressed as water stability index, which was expressed as the percent of remained dry matter of sample after being disintegrated in the water. The results of conductometric method were shown as conductivity curves for each sample, giving the insight in rate of nutrient leaching during the time. The obtained values of water conductivity showed no significant (p < 0.05) correlation with the results of static water method, while there was a negative significant (p < 0.05) correlation with the results of wet sieving method during first four hours of pellets soaking in water. The highest correlation coefficients were obtained within the first hour of conductivity measurement, demonstrating that proposed conductometric method had a potential to be applied as a rapid and simple method for determination and relative comparison of salmon feed water stability.[ Project of the Serbian Ministry of Education, Science and Technological Development, Grant no. III46012 and Grant no. TR31011]

In recent years there is an emerging trend of coarse grinding of cereals in production of poultry feed due to positive influence of coarse particles on poultry digestive system. Influence of grinding method (hammer mill vs. roller mill) and grinding intensity of corn (coarseness of grinding) on mill specific energy consumption and pellet quality was investigated. By decreasing grinding intensity of corn (coarser grinding), specific energy consumption of both hammer mill and roller mill was significantly decreased (p < 0.05). When comparing similar grinding intensities on hammer mill and roller mill (similar geometric mean diameter or similar particle size distribution), specific energy consumption was higher for the hammer mill. Pellet quality decreased with coarser grinding on hammer mill but, however, this effect was not observed for the roller mill. Generally, pellet quality was better when roller mill was used. It can be concluded that significant energy savings could be achieved by coarser grinding of corn before pelleting and by using roller mill instead of hammer mill. From the aspect of pellet quality, if coarser grinding is applied it is better to use roller mill, concerning that more uniform particle size distribution of corn ground on roller mill probably results in more uniform particle size distribution in pellets and this provides better pellet quality. [Projekat Ministarstva nauke Republike Srbije, br. III 46012]

Literature data about nutritional characteristics of linseed cultivars from some specific geographical area or country is scarce. For that very reason, following paper is presenting fatty acid (FA) compositions and antioxidant capacity of lipid-soluble (ACL) components of ten native linseed cultivars from Serbia. These characteristics can be interesting, especially due to the increasing trend of linseed usage in human diet. Presented results show that there were statistically significant (p

Тhe paper presents results of the investigation of the influence of extrusion temperature and moisture content of treated material on the reduction of cyanogenic glycosides (CGs) in linseed-based co-extrudate. CGs are the major limitation of the effective usage of linseed in animal nutrition. Hence, some technological process must be applied for detoxification of linseed before its application as a nutrient. Extrusion process has demonstrated several advantages in reducing the present CGs, since it combines the influences of heating, shearing, high pressure, mixing, etc. According to obtained results, the increase in both temperature and moisture content of the starting mixture decreased the content of CGs in the processed material. HCN content, as a measurement of GCs presence, ranged from 25.42 mg/kg, recorded at the moisture content of 11.5%, to 126 mg/kg, detected at the lowest moisture content of 7%. It seems that moisture content and temperature had the impact on HCN content of equal importance. However, the influence of extrusion parameters other than temperature and moisture content could not be neglected. Therefore, the impact of individual factors has to be tested together. [Projekat Ministarstva nauke Republike Srbije, br. III 46012]

Based on the formulations of the ingredient mixtures and setting up the details of the extrusion technology 4 floating complementary carp feeds were developed suitable for inclusion of high oil levels by vacuum coating technology. The experimental feeds were manufactured in pilot scale and the efficiency of oil supplementation after application of vacuum coating was checked by GC determination of feed fatty acid composition. The amounts of fortifying long chain polyunsaturated fatty acid (LcPUFA) containing oils - Mortierella alpine oil, containing 40% arachidonic acid in triglyceride form (ARA); eicosapentaenoic (EPA) and docosahexaenoic (DHA) ethyl esters - were as follows: Feed CF2: 6.0% Linseed oil (LSO); CF3: 3.5% LSO + 1.5% Arachidonic acid (ARA) + 1% DHA; CF4: 6.0% Fish oil (FO); CF5: 4.5% FO + 1.5% ARA. The control sinking feed (CF1) was supplemented with 6.0% Soybean oil (SBO). The fatty acid composition determined by capillary gas chromatography well reflected the fortification. The experimental feeds were tested in a feeding experiment with common carp under intensive RAS rearing conditions. The experimental feeds and the control sinking one were fed to fish in parallel groups at constant water temperature (average: 23.9±0.3 °C), with an average oxygen saturation of 90±2 %. Fish were grown steadily, the best growth rate (SGR) and feed conversion rate (FCR) both were found in the FO fed group (1.17±0.00 %/day and 2.02±0.12 g/g). In the feeds highest levels for 18:3n3, 20:4n6 and 22:6n3 were 27.6%, 9.2%, and 11.2%, respectively. Whereas for the above mentioned fatty acids the highest levels of 7.3%, 2.3%, and 2.3%, respectively, were found in the carp fillets, the estimated EPA+DHA contents of the fillet were 5 to 12 times higher in the fillets offish fed on fortified feeds than in those offish fed on control feed CF1. Fortified floating feeds can be applied as complementary feed along with sufficient levels of natural food in fish ponds in suitable feeding regimes. A suitable feeding regime was suggested to apply the complementary feeds. [ABSTRACT FROM AUTHOR]