Search

Effective management of water quality in watersheds is crucial because it is directly linked to the sustainability of aquatic ecosystems. In conventional watershed management, best management practices (BMPs) have been instrumental in addressing deteriorating water quality issues caused by non-point source pollution. Greenhouse gas (GHG) emissions have emerged as a global concern, necessitating immediate and diverse environmental actions to mitigate their impacts. This study aims to explore BMPs that maximize total phosphorus (TP) load removal efficiencies, while minimizing costs and GHG emissions within watersheds, using the Soil and Water Assessment Tool (SWAT) and non-dominated sorting genetic algorithm III (NSGA-III). The Yeongsan River Watershed between 2012 and 2021 was selected as the study area. Hydrological and BMP data were analyzed. Applying identical BMPs to the watershed showed that the BMPs with high TP removal efficiency may not be effective in terms of cost and GHG emissions. Therefore, the optimal combination of BMPs for the Yeongsan River Watershed was determined using NSGA-III considering TP removal efficiency, cost, and GHG emissions. This study is the first to consider GHG emissions at the watershed level when applying BMPs and is expected to contribute to the development of BMP implementation incorporating GHG emissions.

The numerical study was conducted to compare process performance depending on the pump type and process configuration. The daily monitoring data of seawater temperature and salinity offshore from Daesan, Republic of Korea was used to reflect the site-specific seawater conditions. An algorithm for reverse osmosis in constant permeate mode was developed to simulate the process in time-variant conditions. Two types of pumps with different maximum leachable efficiencies were employed to organize pump-train configuration: separated feed lines and common pressure center design. The results showed pump type and design configuration did not have a significant effect on process performance. The annual means of specific energy consumption (SEC) for every design configuration were under 2 kWh/m3, except for a worst-case. The worst-case was decided when the pump was operated out of the best operation range. The two operation strategies were evaluated to determine the optimal configuration. The permeate flow rate was reduced to 80% of the designed permeate flow rate with two approaches: feed flow rate reduction in every train and pump shutdown in a specific train. The operation mode with feed flow rate reduction was more efficient than the other. The operating pressure reduction led to a decrease in SEC.

The potassium (K) sorption characteristics with three adsorbents, natural zeolite, ammonium acetate-treated zeolite, and manganese nodule, were studied and compared to see the potential use of manganese nodule as an alternative K adsorbent. In general, the Langmuir isotherm could fit the K sorption in the KCl solutions at different pH conditions better than the Freundlich isotherm. Based on the Langmuir parameters, the maximum K sorption was greater for the zeolite-based adsorbents (i.e., 40–42 mg g−1) than the manganese nodule (i.e., 2.0 mg g−1) at acidic conditions, while the manganese nodule (i.e., 9.7 mg g−1) showed better K sorption at neutral conditions. With the seawater samples, the zeolite-based adsorbents showed higher K recovery (4–14%) than the manganese nodule (0–8.8%). The K sorption on the zeolite-based adsorbents followed the pseudo-second-order kinetics and the K sorption rates were higher for the treated zeolite than the natural zeolite. The repeated sorption tests showed that the natural zeolite could potentially be reused up to three times without any significant loss of K sorption capacity, while the ammonium acetate-treated zeolite lost its K sorption capacity after the single sorption test. Overall, the results show that the manganese nodule may potentially be the alternative to zeolite for K recovery under certain conditions, yet the zeolite-based adsorbents are generally better than the manganese nodule. Thus, more studies to enhance the K recovery using zeolite, including surface modified zeolite, are recommended.